GW-7434D # Átjáró, Gateway/DeviceNET Master - Modbus TCP/RTU Slave/RS232, ICP DAS

GW-7434D # Átjáró, Gateway/DeviceNET Master - Modbus TCP/RTU Slave/RS232, ICP DAS
GW-7434D-G CR # Modbus/TCP server to DeviceNet master Gateway (RoHS)

The GW-7434D is an economic solution that provides a communication protocol transformation between the DeviceNet protocol and the Modbus TCP protocol. This module solves the problem to connect an existing DeviceNet network to the Ethernet-based PLC, HMI or SCADA for setting up a control or monitoring system. Different to the GW-7243D, the GW-7434D offers the Predefined Master connection Set function and Group 2 only Server function as a DeviceNet master, and enables accessing the DeviceNet slaves automatically and cyclically. If the PLC, HMI or SCADA would like to access the DeviceNet slaves and simultaneously communicate with the Modbus slaves or COM-based devices connected with the RS-232 or RS-485 port of the GW-7434D, the GW-7434D can be the Modbus TCP server or VxComm server to exchange the data with those devices.

• Programmable DeviceNet Master MAC ID
• Programmable DeviceNet transfer-rate 125K, 250K, 500K
• Supports maximum DeviceNet devices up to 63
• Predefined Master/Slave Connection Set
• Devicenet I/O Length: 128 bytes max. (Input/Output) per DeviceNet slave
• Total DeviceNet I/O Length: 1280 bytes max. (Input/Output) for all DeviceNet slaves
• Supports I/O Operation Mode: Poll, Bit-Strobe and Change Of State/Cyclic
• Supports maximum 512 bytes Modbus I/O datas for DeviceNet I/O to map
• Supports on-line adding device into and removing device from network
• Converters single Modbus/TCP to multi Modbus/RTU, setting by Utility
• Supports VxComm technique for every COM ports of controllers, setting by Utility
• Allowed multi-client (or master) access simultaneously
• Support "Set/Get Explicit Message" methods via Modbus TCP/RTU command
• Supports Modbus RTU to DeviceNet master, setting by Utility

We have communicated with the following DeviceNet slaves

1. Allen-Bradley PowerFlex series DeviceNet Inverters
2. BECKHOFF CX1500-B520 series DeviceNet I/O modules
3. BECKHOFF BK5250 series DeviceNet I/O modules
4. MKS 683 series DeviceNet exhaust throttles
5. MKS MFC (Mass Flow Controller) series DeviceNet devices
6. MKS DELTA II FRC (Flow Ratio Controller) series DeviceNet devices
7. MKS DC Power Generator (OPT- xxx) series DeviceNet devices
8. OMRON DRT1-ID/ODxx series DeviceNet I/O modules
9. OMRON DRT2-MDxx series DeviceNet I/O modules
10. COSMOS PS-7 series DeviceNet gas detectors
11. CELERITY UNIT IFC-125 series DeviceNet devices
12. Allen-Bradley PowerFlex AC Drives
13. Allen-Bradley PowerFlex AC Drives with DriveLogix
14. Allen-Bradley PowerFlex DC Drives
15. OMRON DRT2-ID08(-1)/MD16
16. OMRON DRT2-OD08/MD16-1
17. OMRON DRT2-OD08-1
18. OMRON DRT2-ID16(-1)/OD16(-1)
19. OMRON GRT1-DRT
20. OMRON C200HW-DRT21
21. Swagelok MS-VCM-D-6-0, MS-VCM-D-6-2 Digital DeviceNet Valve
22. Swagelok SS-PTX-D-G500-S4-K Digital DeviceNet Pressure-Temperature Transducer
23. Swagelok SS-PTX-D-G500-SM-K Digital DeviceNet Pressure-Temperature Transducer
24. Weidmueller SAI-AU M12 DN 16DI/8DO
25. Weidmueller SAI-AU M12 DN GW 16DI
26. Weidmueller SAI-AU M12 DN AI/AO/DI
27. ADVANCED ENERGY Apex RF generators and power-delivery
28. SMC ITV series Electro-Pneumatic Regulator
29. SMC Directional Control Valves
30. SICK DME500 series Distance Sensor
31. MTS Temposonics R-Series Position Sensors
32. PFEIFFER VACUUM HiPace series turbopumps

The GW-7434D provides centralized data storage, “Internal Memory”, for data that is shared between the DeviceNet and Modbus/TCP network. Data is placed into the “Internal Memory” by one network interface, allowing the data to be read/wrote through the other network interface.

Application 1: Modbus TCP/RTU slave to DeviceNet master gateway The GW-7434D can act as a Modbus TCP/RTU slave to DeviceNet master gateway. Using the module, users don’t need to take care of the detail of the DeviceNet protocol. The module will implement the DeviceNet protocol automatically. It mainly supports the Predefined Master/Slave Connection Set functions to allow users to merge I/O data into DeviceNet network by using Modbus TCP/RTU commands. Application 2: a single Modbus/TCP to multi-Mosbus/RTU converter GW-7434D can be a single Modbus/TCP to multi-Modbus/RTU converter. You can simple use the Utility software to configure the device and then set connection between SCADA, HMI software and the GW-7434D. Application 3: protocol converter with VxComm technique GW-7434D can also be able to link to serial devices that don’t support Modbus/RTU. To use this function, you will need to install VxComm driver on host PCs. After installation, you will be able to access the remote COM ports via the standard serial driver.
Hardware EEPROM 16 KB; Data retention: 40 years; 1,000,000 erase/write cycles Watchdog Watchdog IC CAN Interface Controller NXP SJA1000T with 16 MHz clock Transceiver NXP 82C250 Connector 5-pin screwed terminal block (CAN_L, CAN_H, N/A for others) Isolation 1000 VDC for DC-to-DC, 2500 Vrms for photo-couple Protocol DeviceNet Volume I ver2.0, Volume II ver2.0 UART Interface COM 1 RS-232 COM 1 Connector 5-pin screwed terminal block (TxD, RxD, RTS, CTS, GND ) COM 2 RS-485 (Self-turner inside) COM 2 Connector 2-pin screwed terminal block (DATA+, DATA-) Ethernet Interface Controller 10/100Base-TX Ethernet Controller (Auto-negotiating, Auto_MDIX) Connector RJ-45 with LED indicator Protocol Modbus TCP Power Power supply Unregulated +10 ~ +30 VDC Protection Power reverse polarity protection, Over-voltage brown-out protection Power Consumption 2.5 W Mechanism Dimensions 72mm x 122mm x 33mm (W x L x H) Environment Operating Temp. -25 ~ 75 ℃ Storage Temp. -30 ~ 80 ℃ Humidity 10 ~ 90% RH, non-condensing
GW-7434D-G Modbus/TCP server to DeviceNet master Gateway GW-7434D-G CR Modbus/TCP server to DeviceNet master Gateway (RoHS)

RS-232, RS-422, RS-485 konverterek, Ethernet konverterek, RS-485 I/O, Modus I/O, Soros-Ethernet konverterek, USB I/O, Ethernet I/O, Profibus, M-bus, Rádió modem, Ethernet switch, CAN, CANopen, DeviceNet, Profinet, HART, BACnet, EtherCAT, EtherNet/IP, Wireless MBus, DALI, ZigBee, LoRaWan, SIGFOX, IoT, TouchPAD  Fogyasztásmérés és leolvasás  USB konverter  ICP DAS HUNGARY

RS-232 - WiFi konverter, RS-485 - WiFi konverter,

ICP CON konverter    USR IOT konverter

Sinus-Elektrotechnikai Bt.   ICP DAS HUNGARY

RS-232 konverter, RS-422 konverter, RS-485 konverter, RS-485 repeater, USB konverter, Soros Ethernet konverter, RS-232 Ethernet konverter, RS-422 Ethernet konverter, RS-485 Ethernet konverter, Ipari Ethernet switch, Managed DIN switch, PAC, PLC, HMI, Programozó kábel, Ipari monitor, Ipari éritőképernyős monitor, Ipari PC, Ipari laptop, Ipari tablet, Ipari panel PC,  Barebone PC, Mini ITX PC, RS-485 I/O, Profibus I/O modul, Profibus gateway, Profibus konverter, Profibus átjáró, Profibus csatlakozó, Modbus I/O, Ethernet I/O, Modbus gateway, CAN konverter, CAN I/O, CANopen konverter és I/O, DeviceNet konverter és I/O, Hart konverter, Ethernet/IP modul és konverter, BACnet/IP modul és konverter, PROFINET konverter, I/O modul, EtherCAT modul, M-Bus modul, konverter, DALi modul, DALI konverter, PLC programozó kábel, Siemens programozó kábel, WiFi I/O, GSM modem, GPRS modem, SMS küldő, ZigBee konverter, ZigBee I/O, Bluetooth modul, LoRaWAN modul, SIGFOX Modul, IIoT MQTT modul, Média konverter, Touch Pad, Optikai leolvasófej, Analóg, Digitális, Soros PCI kártyák, Épület automatizálás, Ipari tápegység, Ipari kamera, MachineVision, Fogyasztásmérés és elemzés, Földrengés előjelzés, Adatgyűjtés eszközei,  Rezgés elemzés, konverter és repeater, Profibus kábel, Profibus csatlakozó, Soros RS-232 RS-485 WiFi konverter, Ipari Gigabit Ethernet switch, WiFi i/o modul, IEC 1107 mérőleolvasás, Optikai leolvasó fej ICP DAS, ICPDAS, ICP CON, MOXA, ADEUNIS, USR IOT, IEI, B+B SmartWorx, ELKO EP, EXSYS, LILLIPUT, STARTECH, PATTON

All product names, trademarks, brands and logos used on this site are the property of their respective owners. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to indicate any affiliation with or authorisation by any rights holder.

© 2018-2022  Sinus-Elektrotechnikai Bt.  Minden jog fenntartva.

A műszaki adatok és információk előzetes értesítés nélkül megváltozhatnak.