GW-7552-B # Profibus- Modbus RTU átjáró, gateway, ICP DAS

ICP DAS GW-7552-B CR # Profibus- Modbus RTU átjáró, gateway   The GW-7552 Gateway is specially designed for the slave device of PROFIBUS DP protocol. It allows the PROFIBUS master to access the Modbus devices. These Modbus devices may be a PLC, a sensor, ICPDAS M-7000 series modules and so forth. In addition, we also provide the utility software for users to configure the GW-7552. By using this module, users can put their Modbus devices into PROFIBUS network very easily.
Features
Protocol & Hierarchy DP-V0 Slave Supports PROFIBUS Transmission Rate (Kbps) 9.6, 19.2, 45.45, 93.75, 187.5, 500, 1500, 3000, 6000, 12000 Transmission Rate Setting detected automatically Max Input Data Length 132 Bytes Max Output Data Length 131 Bytes Address Setting 0~126 set by DIP switch Supports Modbus Mode Master/Slave Supports Modbus Format RTU/ASCII Hybrid COM 1 RS-232/422/485 with “Self Tuner” inside Supports COM 1 Baudrate (Kbps) 2.4, 4.8, 9.6, 19.2, 38.4, 57.6, 115.2 Supports COM 1 Data Format 7/8 data bits, No/Odd/Even parity, 1/2 stop bit Indicators PWR, ERR, and RUN LEDs Network Isolation Protection High Speed iCoupler DC Isolation Protection 3000VDC on PROFIBUS side
Utility
The GW-7552 Utility helps users to configure the devices, and has following features: Provide GW-7552 safe value setting Display module parameters of the GW-7552 Show module address configuration of the GW-7552
Modules Support
Only the following Modbus commands are supported by the gateway. Code Name Description 01 Read Coil Status Read the ON/OFF status of discrete outputs in the slave 02 Read Input Status Read the ON/OFF status of discrete inputs in the slave 03 Read Holding Registers Read the binary contents of holding registers in the slave 04 Read Input Registers Read the binary contents of input registers in the slave 05 Force Single Coil Write a single output to either ON or OFF in the slave 06 Preset Single Register Write an integer value into a single register in the slave 15 Force Multi. Coils Write each coil in the sequence of coils to either ON or OFF in the slave 16 Preset Multi. Registers Write a block of contiguous registers in the slave
Hardware Specifications
Hardware CPU 80186, 80 MHz or compatible SRAM/Flash/EEPROM 512 KB / 512 KB / 16 KB Watchdog Watchdog IC CPU built-in ESD Protection 4 kV class A PROFIBUS Interface Controller Siemens SPC3 Transceiver ADI ADM2486 Connector 9-pin female D-Sub Baud Rate (bps) 9.6 k, 19.2 k, 45.45 k, 93.75 k, 187.5 k, 500 k, 1.5 M, 3 M, 6 M, 12 M Transmission Distance (m) Depend on baud rate (for example, max. 1200 m at 9.6 kbps ) Isolation 3000 VDC for DC-to-DC, 2500 Vrms for bus-to-logic Protocol DP-V0 UART Interface COM RS-232/RS-422/RS-485(can’t be used simultaneously) COM Connector 3-pin screwed terminal block (RxD, TxD, GND) 4-pin screwed terminal block (RxD+, RxD-, TxD+, TxD-) 2-pin screwed terminal block (DATA+, DATA-) Baud Rate (bps) 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 Data bit 7, 8 Stop bit 1, 2 Parity None, Even, Odd LED Round LED PWR LED, RUN LED, ERR LED Power Power supply Unregulated +10 ~ +30 VDC Protection Power reverse polarity protection, Over-voltage brown-out protection Power Consumption 2.5 W Mechanism Installation DIN-Rail Dimensions 72 mm x 33 mm x 119 mm (W x L x H) Environment Operating Temp. -25 ~ 75℃ Storage Temp. -30 ~ 85℃ Humidity 5 ~ 95% RH, non-condensing
Ordering Information
GW-7552-B CR PROFIBUS/Modbus Gateway (RoHS)

RS-232, RS-422, RS-485 konverterek, Ethernet konverterek, RS-485 I/O, Modus I/O, Soros-Ethernet konverterek, USB I/O, Ethernet I/O, Profibus, M-bus, Rádió modem, Ethernet switch, CAN, CANopen, DeviceNet, Profinet, HART, BACnet, EtherCAT, EtherNet/IP, Wireless MBus, DALI, ZigBee, LoRaWan, SIGFOX, IoT, TouchPAD  Fogyasztásmérés és leolvasás  USB konverter  ICP DAS HUNGARY

RS-232 - WiFi konverter, RS-485 - WiFi konverter,

ICP CON konverter    USR IOT konverter

Sinus-Elektrotechnikai Bt.   ICP DAS HUNGARY

RS-232 konverter, RS-422 konverter, RS-485 konverter, RS-485 repeater, USB konverter, Soros Ethernet konverter, RS-232 Ethernet konverter, RS-422 Ethernet konverter, RS-485 Ethernet konverter, Ipari Ethernet switch, Managed DIN switch, PAC, PLC, HMI, Programozó kábel, Ipari monitor, Ipari éritőképernyős monitor, Ipari PC, Ipari laptop, Ipari tablet, Ipari panel PC,  Barebone PC, Mini ITX PC, RS-485 I/O, Profibus I/O modul, Profibus gateway, Profibus konverter, Profibus átjáró, Profibus csatlakozó, Modbus I/O, Ethernet I/O, Modbus gateway, CAN konverter, CAN I/O, CANopen konverter és I/O, DeviceNet konverter és I/O, Hart konverter, Ethernet/IP modul és konverter, BACnet/IP modul és konverter, PROFINET konverter, I/O modul, EtherCAT modul, M-Bus modul, konverter, DALi modul, DALI konverter, PLC programozó kábel, Siemens programozó kábel, WiFi I/O, GSM modem, GPRS modem, SMS küldő, ZigBee konverter, ZigBee I/O, Bluetooth modul, LoRaWAN modul, SIGFOX Modul, IIoT MQTT modul, Média konverter, Touch Pad, Optikai leolvasófej, Analóg, Digitális, Soros PCI kártyák, Épület automatizálás, Ipari tápegység, Ipari kamera, MachineVision, Fogyasztásmérés és elemzés, Földrengés előjelzés, Adatgyűjtés eszközei,  Rezgés elemzés, konverter és repeater, Profibus kábel, Profibus csatlakozó, Soros RS-232 RS-485 WiFi konverter, Ipari Gigabit Ethernet switch, WiFi i/o modul, IEC 1107 mérőleolvasás, Optikai leolvasó fej ICP DAS, ICPDAS, ICP CON, MOXA, ADEUNIS, USR IOT, IEI, B+B SmartWorx, ELKO EP, EXSYS, LILLIPUT, STARTECH, PATTON

All product names, trademarks, brands and logos used on this site are the property of their respective owners. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to indicate any affiliation with or authorisation by any rights holder.

© 2018-2020  Sinus-Elektrotechnikai Bt.  Minden jog fenntartva.

A műszaki adatok és információk előzetes értesítés nélkül megváltozhatnak.