- Újdonságok
- Akciós termékek
- Raktáron (szállítás 2-4 nap)
- Outlet
- Konverter, vonalerősítő, hub
- Soros - Ethernet konverter, RS-232, RS-422, RS-485
- Ethernet switch
- PAC - PLC - Érintőképernyős PLC - HMI
- ICP DAS Bővítő kártyák # X-Board, XV-Board, XW-Board
- RS-485 portos terepi I/O [Modbus, DCON]
- Ethernet I/O modulok
- USB I/O modulok
- Profibus [konverter, vonalerősítő, átjáró, I/O, csatlakozó, kábel]
- Modbus modulok
- CAN modulok, kártyák
- CANopen modulok, kártyák
- DeviceNet modulok, kártyák
- SAE J1939 modulok
- HART modulok
- EtherNet/IP modulok
- BACnet/IP modulok
- BACnet MS/TP modulok
- PROFINET modulok
- EtherCAT modulok
- M-Bus [Meter-Bus] modulok
- W-MBUS [Wireless-MBUS]
- DALI (Digital Addressable Lighting Interface)
- Data Highway Plus
- PLC programozó kábel és szerszámgép kábel a legtöbb ismert márkához
- Jelkondícionáló modul
- Ipari Panel PC
- Ipari számítógép
- Ipari notebook és tablet
- Ipari és kereskedelmi monitor
- HMI kijelzők
- WiFi eszközök
- Fogyasztásmérés, PMMS, mérőleolvasás, teljesítménymérő gyűjtés
- GSM, GPRS, SMS, GPS, M2M
- ZigBee termékek
- Rádió modem [RF modem, LoRa modem]
- Modbus rádió modemek, RF, 868 MHz
- LoRaWAN eszközök
- SIGFOX eszközök
- Bluetooth
- Infra port, IrDa
- Industrial Internet of Things (IIoT) [MQTT protokoll]
- Ethernet média konverter, extender
- Touch Pad
- Optikai leválasztó, szigetelő, villám és túlfeszültség védelem
- Motion és gépadat gyűjtés
- Hőmérséklet, páratartalom, megvilágítás adatgyűjtő
- PC és külső bővítő kártyák - adatgyűjtés, I/O és interfész (PCI, UPCI, ISA, PCI Express, stb.)
- Épület és Home automatizálás
- KNX termékek
- Kiegészítők (kábel, csatlakozó, stb.)
- Tápegységek
- Automatizálás, vezérlés, szabályozás eszközei
- Machine Vision ipari kamerák és tartozékok
- Kifutott termékek

HRT-310 CR # HART Átjáró/Gateway/Modbus/RTU/ASCII - HART protokoll konverter, ICP DAS
- HRT-310 CR # Átjóró/Modbus/RTU/ASCII - HART protokoll konverter, ICP DAS
- HRT-310 CR # Modbus RTU/ASCII to HART Gateway
- HART Short/Long frame támogatás
- HART Burst mód támogatás
- 2 db HART Master engedélyezés
- Pont-pont vagy multi pont HART mód
- Akár 15 HART modul csatlakoztatása
- Modbus RTU és ASCII formátum támogatása
- Modbus Slave mód támogatása
- Firmware frissítés a Com porton keresztül (FW_v1.2 és HW_v1.2)
- Támogatja a HART készülékek online cseréjét (FW_v1.5)
- Long Frame Address automatikus lekérdezés (FW_v1.5)
- Szigetelt COM Port : RS-232/422/485
- LED kijelző
- Beépített Watchdog
- DIN sínre rögzíthető
-
HRT-310 CR # Átjóró/Modbus/RTU/ASCII - HART protokoll konverter, ICP DAS
HRT-310 CR # Modbus RTU/ASCII to HART GatewayThe HRT-710 / HRT-310 Gateway is specially designed for the master device of HART protocol. It allows the Modbus master to access the HART devices. These HART devices may be a transmitter, an actuator and so forth. In addition, we also provide the software utility, HG_Tool, for module configuration and HART device diagnosis. By using these modules, users can integrate their HART devices into Modbus network easily and quickly.
HRT-710 / HRT-310, a HART master to Modbus slave gateway, is applied to integrate the information from these HART flow meters into the customer's HMI system. Through the HRT-710 / HRT-310, all of the HART flow meters will be regarded as Modbus slave devices and the HMI system can use the built-in Modbus RTU communication to access these HART flow meters easily.
More than 250 HART device information needs to be integrated to surveillance center. In PC side, uses 3 pieces of PCI cards (VXC-148U, for 24 channels RS-485 expansion). I-2542A and I-2542B (RS-485 to Fiber) are used in every RS-485 channel to extend RS-485 communication distance. There are about 20 pieces of HRT-710 modules used in every RS-485 channel with the different station ID. Through the structure, SCADA or HMI system can integrate all HART device information via Modbus protocol easily and quickly.
HRT-710 HRT-310 Din Rail Installation Horizontal Upright HART Signal Standard Enhanced send/receive signal
(For long distance comm.)Loop Power No Support
(module provides +30V output)Built-In Resistor 250 Ohm (1/4W) 250 Ohm (1W) Utility:
- Provide the system and communication configuration of HRT-710 / HRT-310
- Provide the Modbus address table for HART command data
- Provide the diagnostic information of HRT-710 / HRT-310 module and HART device
- Provide send / receive HART command to access HART device
- Provide "Load/Save" module configuration file to apply to other HRT-710 / HRT-310 quickly
Támogatott Modbus parancsok:
CodeNameDescription01Read Coil StatusRead the ON/OFF status of discrete outputs in the slave02Read Input StatusRead the ON/OFF status of discrete inputs in the slave03Read Holding RegistersRead the binary contents of holding registers in the slave04Read Input RegistersRead the binary contents of input registers in the slave05Force Single CoilWrite a single output to either ON or OFF in the slave06Preset Single RegisterWrite an integer value into a single register in the slave15Force Multi. CoilsWrite each coil in the sequence of coils to either ON or OFF in the slave16Preset Multi. RegistersWrite a block of contiguous registers in the slaveModel Name HRT-710 HRT-310 UART Interface COM Port RS-232(3 wires) / RS-422 / RS-485 Baud Rate (bps) 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 Protocol Modbus RTU / Modbus ASCII Connector 9-pin screwed terminal block 4-pin screwed terminal block HART Interface HART Channel 1 HART Interface 2-pin screwed terminal block HART Device 2-wired or 4-wired HART devices HART Topology Point to Point or Multi-Drop HART Data Only Digital Data HART Frame Type Short and Long Frame Burst Mode Supported Max. HART Device 15 Isolation UL1577 Spec. Loop Resistor 250 Ω (1/4W) by Jumper 250 Ω (1W) by Dip-Switch Loop Power No Yes (module provides +30V output) Power Power supply Unregulated +10 ~ +30 VDC Protection Power reverse polarity protection, Over-voltage brown-out protection Power Consumption 1 W 3.5W (Max.) Mechanism Installation DIN-Rail or Wall Mounting (Horizontal) DIN-Rail (Upright) Dimensions 72 mm x 35 mm x 121 mm (W x L x H) Detail 25 mm x 116 mm x 120 mm (W x L x H) Environment Operating Temp. -25 ℃ ~ +75 ℃ Storage Temp. -30 ℃ ~ +80 ℃ Humidity 5% ~ 95% RH, non-condensing HRT-710 CRModbus RTU/ASCII to HART Gateway (RoHS)HRT-310 CRModbus RTU/ASCII to HART Gateway (Upright) (RoHS)s!nus-elektrotechnikai bt.
Industrial IT & Automation
23 éves jubileum / 23 th Anniversary
Email: info@s-e.hu # Tel: 96/525530 # Fax: 96/525531 # Mobil: 30/9464608
RS-232, RS-422, RS-485 konverterek, Ethernet konverterek, RS-485 I/O, Modus I/O, Soros-Ethernet konverterek, USB I/O, Ethernet I/O, Profibus, M-bus, Rádió modem, Ethernet switch, CAN, CANopen, DeviceNet, Profinet, HART, BACnet, EtherCAT, EtherNet/IP, Wireless MBus, DALI, ZigBee, LoRaWan, SIGFOX, IoT, TouchPAD Fogyasztásmérés és leolvasás USB konverter ICP DAS HUNGARY
RS-232 - WiFi konverter, RS-485 - WiFi konverter,
ICP CON konverter USR IOT konverter
Sinus-Elektrotechnikai Bt. ICP DAS HUNGARY
RS-232 konverter, RS-422 konverter, RS-485 konverter, RS-485 repeater, USB konverter, Soros Ethernet konverter, RS-232 Ethernet konverter, RS-422 Ethernet konverter, RS-485 Ethernet konverter, Ipari Ethernet switch, Managed DIN switch, PAC, PLC, HMI, Programozó kábel, Ipari monitor, Ipari éritőképernyős monitor, Ipari PC, Ipari laptop, Ipari tablet, Ipari panel PC, Barebone PC, Mini ITX PC, RS-485 I/O, Profibus I/O modul, Profibus gateway, Profibus konverter, Profibus átjáró, Profibus csatlakozó, Modbus I/O, Ethernet I/O, Modbus gateway, CAN konverter, CAN I/O, CANopen konverter és I/O, DeviceNet konverter és I/O, Hart konverter, Ethernet/IP modul és konverter, BACnet/IP modul és konverter, PROFINET konverter, I/O modul, EtherCAT modul, M-Bus modul, konverter, DALi modul, DALI konverter, PLC programozó kábel, Siemens programozó kábel, WiFi I/O, GSM modem, GPRS modem, SMS küldő, ZigBee konverter, ZigBee I/O, Bluetooth modul, LoRaWAN modul, SIGFOX Modul, IIoT MQTT modul, Média konverter, Touch Pad, Optikai leolvasófej, Analóg, Digitális, Soros PCI kártyák, Épület automatizálás, Ipari tápegység, Ipari kamera, MachineVision, Fogyasztásmérés és elemzés, Földrengés előjelzés, Adatgyűjtés eszközei, Rezgés elemzés, konverter és repeater, Profibus kábel, Profibus csatlakozó, Soros RS-232 RS-485 WiFi konverter, Ipari Gigabit Ethernet switch, WiFi i/o modul, IEC 1107 mérőleolvasás, Optikai leolvasó fej ICP DAS, ICPDAS, ICP CON, MOXA, ADEUNIS, USR IOT, IEI, B+B SmartWorx, ELKO EP, EXSYS, LILLIPUT, STARTECH, PATTON
All product names, trademarks, brands and logos used on this site are the property of their respective owners. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to indicate any affiliation with or authorisation by any rights holder.
© 2018-2020 Sinus-Elektrotechnikai Bt. Minden jog fenntartva.
A műszaki adatok és információk előzetes értesítés nélkül megváltozhatnak.
-
Gyártó ICP DASRaktárkészlet NINCSCikkszám HRT-310_CRStátusz Rendelésre 4-10 munkanap