I-7088D # I/O Module/DCON/8 Counter/8 DO/LED, ICP DAS, ICP CON

The I-7088 provides 8-channel PWM (Pulse Width Modulation) Output and 8-channel Counter Input, and can be used to develop powerful and cost-effective analog control systems. PWM is a powerful technique for controlling analog circuits that uses the Digital Output to generate a waveform with a variable duty cycle and frequency which can then be used to control an analog circuit in applications such as controlling the position or speed of motors, the brightness of lamps, or the speed of fans, etc. Either burst mode or continuous mode can be used for the PWM output depending on the application. In addition, all Digital Input channels can be used as high-speed counters with a speed of up to 1 MHz. The M-7088 supports both the Modbus RTU and the DCON protocols, which can be confi gured via software, and all hardware specifi cations are the same as the I-7088. The I-7088(D)/S and M-7088(D)/S allows the load voltage to be increased from +3.5 to +50 V for the 8-channels PWM (Pulse Width Modulation) output and the 8-channels high-speed counter.     Controlling Motor Position/Speed Dimming Lamp Brightness Controlling Fan Speed     Model I-7088 I-7088D I-7088/S I-7088D/S M-7088 M-7088D M-7088/S M-7088D/S Counter Input Channels 8 Contact Wet Sink/Source (NPN/PNP) Sink On Voltage Level +3.5 ~ +5 VDC +3.5 ~ +50 VDC Off Voltage Level +1 VDC Max. +1 VDC Max. Programmable Filter - Programmable Threshold Voltage - Counter Bits 32-bit Counter Mode Up Encoder Mode - Frequency Mode - Virtual Battery Backup Yes Frequency Accuracy - Max. Speed 1 MHz PWM Output Channels 8 Type PWM, TTL Sink/Source (NPN/PNP) Sink Load Voltage +5 VDC +5 ~ +50 VDC Max. Load Current Sink +5 VDC @ 10 mA/Channel +50 VDC @ 200 mA/Channel Source +5 VDC @ 1 mA/Channel - PWM Frequency 1 Hz ~ 500 KHz Duty Cycle 0.1 to 99.9% Mode Burst, Continuous Burst Count 1 to 65535 Trigger Start Hardware or Software Power-on Value - Safe Value -   Model I-7088 I-7088D I-7088/S I-7088D/S M-7088 M-7088D M-7088/S M-7088D/S Communication Interface RS-485 Bias Resistor No (Usually supplied by the RS-485 Master. Alternatively, add a tM-SG4 or SG-785.) Format (N, 8, 1) (N, 8, 2) (E, 8, 1) (O, 8, 1) Baud Rate 1200 to 115200 bps Protocol DCON Modbus RTU, DCON Dual Watchdog Yes, Module (1.6 Seconds), Communication (Programmable) LED Indicator/Display System LED Indicator Yes, 1 as Power/Communication Indicator I/O LED Indicator 7-segment 7-Segment LED Display - Yes - Yes Isolation Intra-module Isolation, Field-to-Logic 2500 VDC EMS Protection ESD (IEC 61000-4-2) ±4 kV Contact for each Terminal EFT (IEC 61000-4-4) ±4 kV for Power Line Surge (IEC 61000-4-5) - Power Reverse Polarity Protection Yes Format +10 ~ +30 VDC  Baud Rate 2.9 W 3.4 W 2.9 W 3.4 W Mechanical Dimensions (L x W x H) 123 mm x 72 mm x 35 mm Installation DIN-Rail or Wall Mounting Environment Operating Temperature -25 to +75°C Storage Temperature -40 to +85°C Humidity 10 to 95% RH, Non-condensing   I-7088-G CR 8-channel PWM Output and 8-channel High-speed Counter Module using the DCON Protocol (Gray Cover) (RoHS) I-7088D-G CR I-7088 with 7-segment LED Display (Gray Cover) (RoHS) M-7088-G CR 8-channel PWM Output and 8-channel High-speed Counter Module using the DCON and Modbus Protocols (Gray Cover) (RoHS) M-7088D-G CR M-7088 with 7-segment LED Display (Gray Cover) (RoHS) I-7088-G/S CR I-7088 with DN-8P8C-CA External Board (Gray Cover) (RoHS) I-7088D-G/S CR I-7088D with DN-8P8C-CA External Board (Gray Cover) (RoHS) M-7088-G/S CR M-7088 with DN-8P8C-CA External Board (Gray Cover) (RoHS) M-7088D-G/S CR M-7088D with DN-8P8C-CA External Board (Gray Cover) (RoHS) I-7088-G/S = DN-8P8C-CA Connects to the I-7088 Directly M-7088-G/S = DN-8P8C-CA Connects to the M-7088 Directly   tM-7520U CR RS-232 to RS-485 converter (RoHS) tM-7561 CR USB to RS-485 converter (RoHS) tM-SG4 CR RS-485 Pull-high/Pull-low and Termination Resistor Module (RoHS) I-7514U CR 4-channel RS-485 Hub (RoHS) SG-770 CR 7 channel differential or 14 channel single-ended surge protector (RoHS) DN-8P8C-CA CR 8-channel Digital Output and 8-channel Counter Input Board, including two CA-090910-A Cable and two CA-3813 Connector CA-090910-A 9-pin Female D-sub Cable for I/M-7088 Connector, 1 m CA-3813 Connector Casing for 13-pin, 3.81 mm Pitch or 14-pin, 3.5 mm Pitch   TOP | HOME

Sinus-Elektrotechnikai Bt.

ICP DAS HUNGARY

RS-232 konverter, RS-422 konverter, RS-485 konverter, RS-485 repeater, USB konverter, Soros Ethernet konverter, RS-232 Ethernet konverter, RS-422 Ethernet konverter, RS-485 Ethernet konverter, Ipari Ethernet switch, Managed DIN switch, PAC, PLC, HMI, Programozó kábel, Ipari monitor, Ipari éritőképernyős monitor, Ipari PC, Ipari laptop, Ipari tablet, Ipari panel PC,  Barebone PC, Mini ITX PC, RS-485 I/O, Profibus I/O modul, Profibus gateway, Profibus konverter, Profibus átjáró, Profibus csatlakozó, Modbus I/O, Ethernet I/O, Modbus gateway, CAN konverter, CAN I/O, CANopen konverter és I/O, DeviceNet konverter és I/O, Hart konverter, Ethernet/IP modul és konverter, BACnet/IP modul és konverter, PROFINET konverter, I/O modul, EtherCAT modul, M-Bus modul, konverter, DALi modul, DALI konverter, PLC programozó kábel, Siemens programozó kábel, WiFi I/O, GSM modem, GPRS modem, SMS küldő, ZigBee konverter, ZigBee I/O, Bluetooth modul, LoRaWAN modul, SIGFOX Modul, IIoT MQTT modul, Média konverter, Touch Pad, Optikai leolvasófej, Analóg, Digitális, Soros PCI kártyák, Épület automatizálás, Ipari tápegység, Ipari kamera, MachineVision, Fogyasztásmérés és elemzés, Földrengés előjelzés, Adatgyűjtés eszközei,  Rezgés elemzés, konverter és repeater, Profibus kábel, Profibus csatlakozó, Soros RS-232 RS-485 WiFi konverter, Ipari Gigabit Ethernet switch, WiFi i/o modul, IEC 1107 mérőleolvasás, Optikai leolvasó fej ICP DAS, ICPDAS, ICP CON, MOXA, ADEUNIS, USR IOT, ATOP, B+B SmartWorx, ELKO EP, EXSYS, LILLIPUT, STARTECH, PATTON

All product names, trademarks, brands and logos used on this site are the property of their respective owners. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to indicate any affiliation with or authorisation by any rights holder.

© 2018-2019  Sinus-Elektrotechnikai Bt.  Minden jog fenntartva!

A műszaki adatok és információk előzetes értesítés nélkül megváltozhatnak.