I-7530-G CR # Intelligens RS-232 - CAN konverter (RoHS)
I-7530T-G CR # Intelligens RS-232 - CAN konverter (RoHS)
I-7530-FT CR # Intelligens RS-232 - CAN alacsony sebességű hibatűrő konverter (RoHS)
CAN (Controller Area Network) is a serial bus system especially suited to structure intelligent industry devices networks and build smart automatic control systems. The following figure shows the application architecture for I-7530/I-7530T/I-7530FT modules. The PC can be the CAN host, monitor or HMI to access/control the CAN device through the CAN network by the I-7530/I-7530T/I-7530FT Converters. The programmable RS-232 device (For example: I-8411/I-8431/I-8811/I-8831/W-8031/W-8331/W-8731 embedded controller) can use the serial port to connect to the CAN network via the I-7530/I-7530T/I-7530FT modules. In order to use the CAN network with traditional RS-232 devices, we provide a way to achieve this purpose. The I-7530/I-7530T/I-7530FT are designed to unleash the power of CAN bus via RS-232 communication method. It accurately converts messages between CAN and RS-232 networks. This module let you to communicate with CAN devices easily from any PC or devices with RS-232 interface.
3000V isolation on CAN side (for I-7530/I-7530T)
The CAN port of I-7530/I-7530T is an isolated with 3000V isolation. This isolation can protect the local RS-232 devices from the damage signal coming from CAN network.
Watchdog inside
The watchdog is a hardware reset circuit to monitor the operation status. When working in harsh or noisy environment, the I-7530/I-7530T/I-7530FT may shut down by the external signal. The circuit may let the I-7530/I-7530T/I-7530FT to work continuously and never halt.
Power and Error indicator display
There are two indicators on the I-7530/I-7530T/I-7530FT.The power indicator can help user to check whether the I-7530/I-7530T/I-7530FT is standby or transmitting/receiving messages. The Error indicator will be turned on when some errors occur on the I-7530/I-7530T/I-7530FT.
| Software Utility Features |
|
|
|
- CAN bus Baud rate configuration
- CAN acceptance filter configuration
- CAN 2.0A or 2.0B specific selection
- RS-232 Baud rate and data bit setting
- RS-232 responded selection
- Easy test to transmit/receive can messages
- Setting for I-7530/I-7530T/I-7530FT communication mode (normal mode or pair connection mode)
|
|
|
|
| CAN Monitor & Datalog Tool |
|
|
|
-
It has a CAN message field which can display the receiving CAN messages in Decimal or HEX mode
-
Can display the timestamp of each received CAN message
-
Users can change the display mode, up-down, down-up or stop
-
It can count the number of received CAN messages
-
Data Log : It can save the CAN message as “ txt ” file
-
Has CAN ID filter function
-
Can send CAN message to CAN BUS according the defined interval time
|
| Performance Test |
|
|
|
The test is the performance which transfer 8 bytes data frame from CAN to RS232. (for I-7530/I-7530T)
|
|
CAN setting
|
Transfer frames
|
Transfer time(ms)
|
RS-232 setting
|
Receive frames
|
Receive time (ms)
|
The max frames/sec
|
Data<8 byes/frme
|
RS232 command length
|
|
2.0A 1Mbps
|
1,000
|
200
|
115200,n,8,1
|
1,000
|
2954
|
338
|
>=338
|
22 B
|
|
2.0A 1Mbps
|
1,000
|
200
|
115200,n,7,1
|
1,000
|
2775
|
360
|
>=360
|
22 B
|
|
2.0B 1Mbps
|
1,000
|
200
|
115200,n,8,1
|
1,000
|
3580
|
279
|
>=279
|
27 B
|
|
2.0B 1Mbps
|
1,000
|
200
|
115200,n,7,1
|
1,000
|
3337
|
299
|
>=299
|
27 B
|
|
The test is the performance which transfer 8 bytes data frame from RS232 to CAN. (for I-7530/I-7530T)
|
|
CAN setting
|
Transfer frames
|
Transfer time (ms)
|
RS-232 setting
|
Receive frames
|
Receive time (ms)
|
The max frames/sec
|
Data<8 byes/frame
|
RS232 command length
|
|
2.0A 1Mbps
|
1,000,000
|
2,612,243
|
115200,n,8,1
|
1,000,000
|
2,612,243
|
382
|
>=382
|
22 B
|
|
2.0A 1Mbps
|
1,000,000
|
2,441,130
|
115200,n,7,1
|
1,000,000
|
2,441,130
|
409
|
>=409
|
22 B
|
|
2.0B 1Mbps
|
1,000,000
|
3,142,043
|
115200,n,8,1
|
1,000,000
|
3,142,043
|
318
|
>=318
|
27 B
|
|
2.0B 1Mbps
|
1,000,000
|
3,142,043
|
115200,n,7,1
|
1,000,000
|
2,966,646
|
337
|
>=337
|
27 B
|
|
|
|
|
| Hardware Specifications |
|
|
|
|
Item
|
I-7530
|
I-7530T
|
I-7530-FT
|
|
Hardware
|
|
EEPROM
|
2 KB (for system information), 100,000 erase/write cycles
|
|
CAN Interface
|
|
Transceiver
|
NXP 82C250
|
NXP TJA1042 |
AMIS 41682
|
|
Channel number
|
1
|
|
Connector
|
9-pin male D-Sub (CAN_L, CAN_H, N/A for others)
|
|
Baud Rate (bps)
|
10 k, 20 k, 50 k, 125 k, 250 k, 500 k, 800 k, 1 Mbps
(allow user-defined CAN baud rate)
|
10 k, 20 k, 50 k, 125 k (allow user-defined CAN baud rate)
|
|
Isolation
|
3000 VDC for DC-to-DC,
2500 Vrms for photo-couple
|
NONE
|
|
Terminator Resistor
|
Selectable 120Ω terminator resistor by jumper
|
1 kΩ for CAN_H and CAN_L
|
|
Specification
|
ISO-11898-2, CAN 2.0A and CAN 2.0B
|
ISO-11898-3 (low speed fault tolerance), CAN 2.0A and CAN 2.0B
|
|
Receive Buffer
|
1000 data frames
|
|
RS-232 Interface
|
|
Connector
|
9-pin female D-Sub (TxD, RxD, GND, N/A for others )
|
|
Baud Rate (bps)
|
110, 150, 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200bps
|
|
Data bit
|
5, 6, 7, 8
|
|
Stop bit
|
1, 2
|
|
Parity bit
|
None, Even, Odd
|
|
Receive Buffer
|
900 data frames
|
|
LED
|
|
Round LED
|
ON LED: Power and Data Flow; ERR LED: Error Status
|
|
Power
|
|
Protection
|
Power reverse polarity protection, Over-voltage brown-out protection
|
|
Power Consumption
|
1 W
|
|
Mechanism
|
|
Installation
|
DIN-Rail
|
|
Dimensions
|
72mm x 118mm x 33mm (W x L x H)
|
|
Environment
|
|
Operating Temp.
|
-25 ~ 75 ℃
|
|
Storage Temp.
|
-30 ~ 80 ℃
|
|
Humidity
|
10 ~ 90% RH, non-condensing
|
|
|
|
|
| Ordering Information |
|
|
|
|
|
Intelligent RS-232 to CAN converter
|
|
|
Intelligent RS-232 to CAN converter (RoHS)
|
|
|
Intelligent RS-232 to CAN converter (RoHS)
|
|
|
Intelligent RS-232/CAN low speed fault tolerant converter
|
|
|
Intelligent RS-232/CAN low speed fault tolerant converter (RoHS)
|
|
|
s!nus-elektrotechnikai bt.
Industrial IT & Automation
|
|
25 éves jubileum / 25 th Anniversary
www.s-e.hu # www. icpdas.hu
Email: info@s-e.hu # Tel: 96/525530 # Fax: 96/525531 # Mobil: 30/9464608
|
RS-232, RS-422, RS-485 konverterek, Ethernet konverterek, RS-485 I/O, Modus I/O, Soros-Ethernet konverterek, USB I/O, Ethernet I/O, Profibus, M-bus, Rádió modem, Ethernet switch, CAN, CANopen, DeviceNet, Profinet, HART, BACnet, EtherCAT, EtherNet/IP, Wireless MBus, DALI, ZigBee, LoRaWan, SIGFOX, IoT, TouchPAD Fogyasztásmérés és leolvasás USB konverter ICP DAS HUNGARY
RS-232 - WiFi konverter, RS-485 - WiFi konverter,
ICP CON konverter USR IOT konverter
Sinus-Elektrotechnikai Bt. ICP DAS HUNGARY
RS-232 konverter, RS-422 konverter, RS-485 konverter, RS-485 repeater, USB konverter, Soros Ethernet konverter, RS-232 Ethernet konverter, RS-422 Ethernet konverter, RS-485 Ethernet konverter, Ipari Ethernet switch, Managed DIN switch, PAC, PLC, HMI, Programozó kábel, Ipari monitor, Ipari éritőképernyős monitor, Ipari PC, Ipari laptop, Ipari tablet, Ipari panel PC, Barebone PC, Mini ITX PC, RS-485 I/O, Profibus I/O modul, Profibus gateway, Profibus konverter, Profibus átjáró, Profibus csatlakozó, Modbus I/O, Ethernet I/O, Modbus gateway, CAN konverter, CAN I/O, CANopen konverter és I/O, DeviceNet konverter és I/O, Hart konverter, Ethernet/IP modul és konverter, BACnet/IP modul és konverter, PROFINET konverter, I/O modul, EtherCAT modul, M-Bus modul, konverter, DALi modul, DALI konverter, PLC programozó kábel, Siemens programozó kábel, WiFi I/O, GSM modem, GPRS modem, SMS küldő, ZigBee konverter, ZigBee I/O, Bluetooth modul, LoRaWAN modul, SIGFOX Modul, IIoT MQTT modul, Média konverter, Touch Pad, Optikai leolvasófej, Analóg, Digitális, Soros PCI kártyák, Épület automatizálás, Ipari tápegység, Ipari kamera, MachineVision, Fogyasztásmérés és elemzés, Földrengés előjelzés, Adatgyűjtés eszközei, Rezgés elemzés, konverter és repeater, Profibus kábel, Profibus csatlakozó, Soros RS-232 RS-485 WiFi konverter, Ipari Gigabit Ethernet switch, WiFi i/o modul, IEC 1107 mérőleolvasás, Optikai leolvasó fej ICP DAS, ICPDAS, ICP CON, MOXA, ADEUNIS, USR IOT, IEI, B+B SmartWorx, ELKO EP, EXSYS, LILLIPUT, STARTECH, PATTON
All product names, trademarks, brands and logos used on this site are the property of their respective owners. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to indicate any affiliation with or authorisation by any rights holder.
© 2018-2022 Sinus-Elektrotechnikai Bt. Minden jog fenntartva.
A műszaki adatok és információk előzetes értesítés nélkül megváltozhatnak.
