Kategóriák

   

 

Szűrés
Gyártó
Kategóriák
Hírlevél
Tanúsítvány
SSL Certificate
Ajándékot keres?

Házhozszállítás

Termék részletek
Főkategória >CAN modulok, kártyák >CAN - Soros RS-232/422/485 konverter
 
 

I-7530A # RS-232/422/485 - CAN konverter, ICP DAS

Rendelésre 4-10 munkanap
Raktárkészlet: NINCS
I-7530A # RS-232/422/485 - CAN konverter, ICP DAS
  • I-7530A # RS-232/422/485 - CAN konverter, ICP DAS
  • I-7530A # RS-232/422/485 - CAN konverter, ICP DAS
  • I-7530A # RS-232/422/485 - CAN konverter, ICP DAS
  • I-7530A # RS-232/422/485 - CAN konverter, ICP DAS
53 602 Ft 68 075 Ft
db Kosárba Kosárba
  • I-7530A CR # RS-232/422/485 - CAN konverter, ICP DAS
  • I-7530A CR # RS-232/422/485 to CAN Converter
  • Kompatibilis a CAN 2.0A és 2.0B specifikációval
  • Teljesen kompatibilis az ISO 11898-2 szabvánnyal
  • Különböző adatsebességek támogatása, 10K bps ~ 1M bps
  • Jumperrel állítható 120 Ω lezáró ellenállás
  • Szoftverrel konfigurálható CAN és RS-232/422/485 kommunikációs paraméterek
  • Power, data flow és error kijelzés a CAN és RS-232/422/485-nek
  • Watchdog 
  • Transzparens kommunikációt biztosít az RS-232/485/422 készülékek és a CAN busz között
  • különböző RS-232/485/422 készülékek és készülék csoportok CAN busz hálózatra kötése
  • (Az RS-232/422 teljes duplex kommunikációja nem biztosított)
  • 3 kV galvanikus leválasztás
  • 2500 Vrms optocsatolós leválasztás a CAN oldalon
  • DIN sínre vagy szerelőlapra rögzíthető
  • Működési hőmérséklet: -25 ~ 75 ℃
Részletek Kiegészítő termékek Hasonló termékek Adatok

  • I-7530A CR # RS-232/422/485 - CAN konverter, ICP DAS
    I-7530A CR # RS-232/422/485 to CAN Converter

     

    The I-7530A is an RS-232/422/485 to CAN converter. It is a member of the I-7530 serial family, and inherits all of the features of the I-7530. The CAN interface of the I-7530A follows ISO 11898-2 specifi cation, the maximum CAN baud is up to 1 Mbps. There is one COM port in the I-7530A. As the I-7530A runs, it only receives the commands from one of these COM interfaces (i.e. from the RS-232, RS-485 or RS-422 interface) at the same time, but the CAN messages will be forwarded to all of these COM interfaces.

     

     

    Moreover, we expand the functionalities of I-7530A for some special application. In pair connection mode, I-7530A can be used to connect PC with other RS-232/485/422 devices at the same time. The application architecture may be as follows.

     

     

    3000V isolation on CAN side
    The CAN port of I-7530A is an isolated with 3000V isolation. This isolation can protect the local RS-232/485/422 devices from the damage signal coming from CAN network.

    Watchdog inside
    The I-7530A Watchdog is a hardware reset circuit to monitor the I-7530A’s operation status. When working in harsh or noisy environment, the I-7530A may be down by the external signal. The circuit may let the I-7530A to work continuously and never halt.

    Power and Error indicator display 
    There are two indicators on the I-7530A.The power indicator can help user to check whether the I-7530A is standby or transmitting/receiving messages. The Error indicator will be turned on when some errors occur on the I-7530A.

    Software Utility Features  
    • CAN bus Baud rate configuration
    • CAN acceptance filter configuration
    • CAN 2.0A or 2.0B specific selection
    • RS-232/485/422 Baud rate and data bit setting
    • RS-232/485/422 responded selection
    • Easy test to transmit/receive CAN messages
    • Setting for I-7530A communication mode (normal mode or pair connection mode)
    		  
     
    CAN Monitor & Datalog Tool  
    • It has a CAN message field which can display the receiving CAN messages in Decimal or HEX mode
    • Can display the timestamp of each received CAN message
    • Users can change the display mode, up-down, down-up or stop
    • It can count the number of received CAN messages
    • Data Log : It can save the CAN message as “ txt ” file
    • Has CAN ID filter function
    • Can send CAN message to CAN BUS according the defined interval time

     

    Performance Test  
    The test is the performance which transfer 8 bytes data frame from CAN to RS232.
    CAN setting
    Transfer frames
    Transfer time(ms)
    RS-232 setting
    Receive frames
    Receive time (ms)
    The max frames/sec
    Data<8 byes/frme
    RS232 command length
    2.0A 1Mbps
    1,000
    200
    115200,n,8,1
    1,000
    2954
    338
    >=338
    22 B
    2.0A 1Mbps
    1,000
    200
    115200,n,7,1
    1,000
    2775
    360
    >=360
    22 B
    2.0B 1Mbps
    1,000
    200
    115200,n,8,1
    1,000
    3580
    279
    >=279
    27 B
    2.0B 1Mbps
    1,000
    200
    115200,n,7,1
    1,000
    3337
    299
    >=299
    27 B
    		 

    The test is the performance which transfer 8 bytes data frame from RS232 to CAN.
    CAN setting
    Transfer frames
    Transfer time (ms)
    RS-232 setting
    Receive frames
    Receive time (ms)
    The max frames/sec
    Data<8 byes/frame
    RS232 command length
    2.0A 1Mbps
    1,000,000
    2,612,243
    115200,n,8,1
    1,000,000
    2,612,243
    382
    >=382
    22 B
    2.0A 1Mbps
    1,000,000
    2,441,130
    115200,n,7,1
    1,000,000
    2,441,130
    409
    >=409
    22 B
    2.0B 1Mbps
    1,000,000
    3,142,043
    115200,n,8,1
    1,000,000
    3,142,043
    318
    >=318
    27 B
    2.0B 1Mbps
    1,000,000
    3,142,043
    115200,n,7,1
    1,000,000
    2,966,646
    337
    >=337
    27 B
    		 
     
    Hardware Specifications  
    Hardware
    EEPROM
    2 KB (for system information), 100,000 erase/write cycles
    CAN Interface
    Transceiver
    NXP 82C250
    Connector
    9-pin male D-Sub (CAN_L, CAN_H, N/A for others)
    Port Channels
    1
    Buad Rate
    10 k, 20 k, 50 k, 125 k, 250 k, 500 k, 800 k, 1 Mbps (allow user-defined CAN baud rate)
    Protection
    3000 VDC power protection on CAN side, 2500Vrms photo-couple isolation on CAN bus
    Terminator Resistor
    Selectable 120Ω terminator resistor by jumper
    Support Protocol
    CAN 2.0A/2.0B
    Receive Buffer
    1000 data frames
    UART Interface
    COM
    RS-232/RS-485/RS-422 (can’t be used simultaneously)
    Connector
    14-pin terminal connector 
    RS-232 : TxD, RxD, GND
    RS-422 : Tx+, Tx-, Rx+, Rx-
    RS-485 : DATA+, DATA-
    Baud Rate
    110, 150, 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 bps
    Data Bits
    5, 6, 7, 8
    Stop Bits
    1,2
    Parity
    None, Even, Odd
    Receive Buffer
    900 data frames
    Power
    Power Consumption
    1W
    Power Requirement
    Unregulated +10VDC ~ +30VDC. Power reverse protection, Over-Voltage brown-out protection
    LED
    Round LED
    ON LED: Power and Data Flow; ERR LED: Error
    Mechanism
    Installation
    DIN-Rail
    Dimensions
    72mm x 118mm x 33mm (W x L x H)
    Environment
    Operating Temp.
    -25℃ to 75℃
    Storage Temp.
    -30℃ to 80℃
    Humidity
    10~90% non-condensing
    		 
     
    Ordering Information  
    I-7530A-G CR
    		 Intelligent RS-232/485/422 to CAN converter (RoHS)
    		 

     

      s!nus-elektrotechnikai bt.

      Industrial IT & Automation

     

    24 éves jubileum / 24 th Anniversary

     www.s-e.hu    #    www. icpdas.hu

    Email: info@s-e.hu    #   Tel:  96/525530    #    Fax: 96/525531    #    Mobil: 30/9464608 

     

    RS-232, RS-422, RS-485 konverterek, Ethernet konverterek, RS-485 I/O, Modus I/O, Soros-Ethernet konverterek, USB I/O, Ethernet I/O, Profibus, M-bus, Rádió modem, Ethernet switch, CAN, CANopen, DeviceNet, Profinet, HART, BACnet, EtherCAT, EtherNet/IP, Wireless MBus, DALI, ZigBee, LoRaWan, SIGFOX, IoT, TouchPAD  Fogyasztásmérés és leolvasás  USB konverter  ICP DAS HUNGARY

    RS-232 - WiFi konverter, RS-485 - WiFi konverter,

    ICP CON konverter    USR IOT konverter

     

    Sinus-Elektrotechnikai Bt.   ICP DAS HUNGARY

    RS-232 konverter, RS-422 konverter, RS-485 konverter, RS-485 repeater, USB konverter, Soros Ethernet konverter, RS-232 Ethernet konverter, RS-422 Ethernet konverter, RS-485 Ethernet konverter, Ipari Ethernet switch, Managed DIN switch, PAC, PLC, HMI, Programozó kábel, Ipari monitor, Ipari éritőképernyős monitor, Ipari PC, Ipari laptop, Ipari tablet, Ipari panel PC,  Barebone PC, Mini ITX PC, RS-485 I/O, Profibus I/O modul, Profibus gateway, Profibus konverter, Profibus átjáró, Profibus csatlakozó, Modbus I/O, Ethernet I/O, Modbus gateway, CAN konverter, CAN I/O, CANopen konverter és I/O, DeviceNet konverter és I/O, Hart konverter, Ethernet/IP modul és konverter, BACnet/IP modul és konverter, PROFINET konverter, I/O modul, EtherCAT modul, M-Bus modul, konverter, DALi modul, DALI konverter, PLC programozó kábel, Siemens programozó kábel, WiFi I/O, GSM modem, GPRS modem, SMS küldő, ZigBee konverter, ZigBee I/O, Bluetooth modul, LoRaWAN modul, SIGFOX Modul, IIoT MQTT modul, Média konverter, Touch Pad, Optikai leolvasófej, Analóg, Digitális, Soros PCI kártyák, Épület automatizálás, Ipari tápegység, Ipari kamera, MachineVision, Fogyasztásmérés és elemzés, Földrengés előjelzés, Adatgyűjtés eszközei,  Rezgés elemzés, konverter és repeater, Profibus kábel, Profibus csatlakozó, Soros RS-232 RS-485 WiFi konverter, Ipari Gigabit Ethernet switch, WiFi i/o modul, IEC 1107 mérőleolvasás, Optikai leolvasó fej ICP DAS, ICPDAS, ICP CON, MOXA, ADEUNIS, USR IOT, IEI, B+B SmartWorx, ELKO EP, EXSYS, LILLIPUT, STARTECH, PATTON

    All product names, trademarks, brands and logos used on this site are the property of their respective owners. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to indicate any affiliation with or authorisation by any rights holder.

     

    © 2018-2020  Sinus-Elektrotechnikai Bt.  Minden jog fenntartva.

    A műszaki adatok és információk előzetes értesítés nélkül megváltozhatnak.